会员登录|免费注册|忘记密码|管理入口 返回主站||保存桌面|手机浏览|联系方式
VIP   VIP会员第1年

Shenzhen Shawn Industrial Co.Ltd  
加关注0

工业用品/胶带

搜索
新闻分类
  • 暂无分类
联系方式


请先 登录 或 注册 后查看


站内搜索
 
荣誉资质
友情链接
  • 暂无链接
首页 > 公司新闻 > Adhesive Transfer Tapes Explained: 465, 468MP, 7952MP and 9473PC
公司新闻
Adhesive Transfer Tapes Explained: 465, 468MP, 7952MP and 9473PC
2026-11-077

Adhesive Transfer Tapes Explained: 465, 468MP, 7952MP and 9473PC

Published by ShenZhen Shawn Industrial Co.,Ltd — November 7, 2026

An adhesive transfer tape has no backing. What you buy is a film of acrylic adhesive sitting on a release liner; when the liner comes off, the adhesive becomes the bond. That single design choice explains both why transfer tapes are specified for thin bond lines and why they are misapplied so often.

What "no carrier" actually changes

Without a carrier, the adhesive can flow into surface micro-texture instead of bridging over it. You get maximum contact area and a bond line measured in tens of microns, which is why transfer tapes are used for nameplates, battery tabs, display frames and gasket lamination. The trade-off is that the tape has almost no ability to absorb shear by itself: if the joint will see peel load, the design needs a foam or cloth carrier instead.

The four grades buyers ask for

3M 465 — a 2 mil (0.05 mm) acrylic transfer adhesive on a densified kraft liner. Thin, general purpose, and the usual starting point for bonding foams, films and papers where a rigid carrier would telegraph through the face material.

3M 468MP — 5 mil (0.13 mm) of acrylic on a 58 lb polycoated kraft liner. Higher adhesive mass than 465, so it tolerates rougher substrates and develops higher peel on metals. Commonly specified for nameplate and panel bonding where 465 is marginal.

3M 7952MP — a double-liner transfer tape. The second liner lets a converter die-cut the part, remove one liner, and hand the exposed adhesive to the next station without the part collapsing. If the assembly is automated, this is the grade to quote.

3M 9473PC — a 10 mil (0.25 mm) transfer adhesive for filling small gaps and bonding textured or slightly mismatched surfaces while keeping the joint thin compared with foam.

Specifying it correctly

Two numbers decide whether a transfer tape works: surface energy of both substrates, and the load the joint carries. Acrylic transfer adhesives bond high and medium surface energy materials (metals, most plastics, glass) without primer. Low surface energy plastics such as unprimed PP or PE need a primer or a different adhesive family.

Application pressure matters more than most assembly lines allow. A transfer tape needs roughly 10 N/cm of roller pressure to wet out; a hand-applied label with light thumb pressure will read low on peel and be blamed on the tape.

Storage is the third lever. These products keep for 24 months at 21 degrees Celsius and 50 percent relative humidity; a summer warehouse at 40 degrees will shorten that considerably and cause liner release problems long before the expiry date printed on the box.

ShenZhen Shawn Industrial Co.,Ltd stocks 3M transfer adhesives in log rolls and slit rolls, and converts them to drawing on a die-cutting press. Send the substrate pair and the load case, and we will confirm the grade and the liner before you commit to a production run.

3M is a trademark of 3M Company. Specifications quoted from the manufacturer's published product data; confirm the current TDS before production release.