Most die-cut tape quotations come back slow, or come back wrong, for the same reason: the drawing shows a shape but not a part. A converter can cut almost anything, but the decisions that determine whether the part works — liner, carrier, tolerance, how it is released from the liner — are not on a shape-only drawing. This note lists what actually removes a round of questions.
1. Material specified by construction, not just by brand
"3M 467MP" is a starting point, not a specification: the same family is supplied on different liners and in different thicknesses, and the liner is what the die-cutter runs. State the construction as: adhesive system, carrier (or none), total thickness without liner, and liner type. If the drawing only names a tape family, expect a question back.
2. The substrate and the release method
| How the part is used | What the converter has to know | What it changes |
| Hand application | Finger-lift tab, extended liner, part count per sheet | Adds a tab or a second liner — cost, but faster assembly |
| Pick-and-place | Liner stiffness, part orientation, sprocket or sheet format | PET liner instead of paper; matrix must release cleanly |
| Applied to a curved surface | Carrier flexibility, adhesive softness | May rule out a stiff PET carrier |
| Removed after transport | Adhesion level, removal window | Low-tack or removable adhesive system |
3. Tolerances that reflect the process
A general tolerance of ±0.2 mm on a 3 mm wide strip is not manufacturable on a rotary press; on a 100 mm gasket it is generous. Give a general tolerance plus critical dimensions — the ones that touch a datum, a connector or a screw boss. Criticals get their own inspection; everything else is held to the general band.
4. Something for the matrix to hold
Very small parts need bridges or a support liner, otherwise the matrix lifts the part with it. If the part is under roughly 5 mm in one direction, say so on the drawing: the converter will add a bridge or hold the part on a carrier, and the quote will reflect it.
5. Quantity, packaging and repeatability
Annual quantity and order pattern — a 500-piece trial and a 200,000-piece programme are tooled differently.
Packaging: sheet, roll, or bagged count; whether the part must stay in registration.
Whether the part will be re-ordered against the same tooling, and who owns the tool.
Any documentation requirement: RoHS, REACH, lot traceability, PPAP-style first article.
6. A drawing that gets a same-day quote
In practice, the drawings that come back fastest carry four things: a PDF with dimensions and a stated scale, the construction written out (adhesive, carrier, thickness, liner), the substrate and the application method, and the annual quantity. Everything else — nesting, bridge placement, tool design — is the converter's job and should be left to them.
What we do
We slit and die-cut in-house on 20 slitting and die-cutting machines, from log roll or from customer-supplied stock, with paper, PET and extended liners. Send a drawing or a width and we quote against it; standard stock widths ship in 3 days, and die-cut samples are quoted on drawing.
Frequently asked
Can you cut from tape we supply?
Yes, subject to a review of the liner and roll condition — paper liners that have absorbed moisture cannot hold registration.
Do we need to pay for tooling?
For rotary die-cutting, yes; the tool is quoted with the part and its ownership is stated on the quotation.
What is the smallest part you can cut?
It depends on the construction and the release method rather than on a fixed number — send the shape and we will say what is feasible and what it costs.
VIP会员
