Most tape enquiries we receive compare price per square metre. The comparison that actually decides whether a purchase order runs smoothly is different: what arrives in the box besides the roll. For an export buyer integrating adhesive tape into a production line, four documents and two physical attributes decide whether the material can be released to production on arrival or sits in quarantine for a week.
The four documents
| Document | Why the buyer needs it | What to check |
| Technical data sheet | Released thickness, adhesive type, adhesion values, temperature range | Revision date and product code match the roll label exactly |
| RoHS declaration | Customs and customer compliance screening | Directive reference, product scope, issuer and date |
| REACH statement | Substance declaration for EU-bound shipments | SVHC list version referenced, not just a generic statement |
| Certificate of conformity / lot record | Traceability from roll back to production batch | Lot or batch number printed on the label and repeated on the document |
A shipment without the lot record is the most common source of delay. When a customer audits an incoming inspection, the roll label and the certificate have to carry the same batch reference. If they do not, the material is treated as unverified regardless of how good the tape is.
The two physical attributes
Thickness tolerance. Published figures are nominal. A 100 µm double coated tape that arrives at 95 µm changes the gap it fills, and on a thin display stack that difference shows up as either a bond line that telegraphs through or a joint that does not close. Ask for the tolerance band, not just the nominal value, and check it against the design gap rather than against the previous supplier's datasheet.
Roll geometry. Log roll length, core diameter and splice policy matter as much as the adhesive. A roll with an unmarked splice inside a converting run stops the machine; a core that does not match the customer's chuck wastes the first metre of every roll. For slit rolls, the stated width should be the usable width, with the tolerance declared.
What we changed in our own supply
Every tape we ship now leaves with the document set above, and the lot number on the carton matches the number on the certificate. Where a manufacturer publishes a thickness tolerance, it is quoted with the product rather than left for the buyer to request. For 3M and tesa constructions we hold in stock, the data sheet revision in the listing is the revision that ships with the order.
What to put in the purchase order
Product code and manufacturer, not just the model number
Nominal thickness and the acceptable tolerance band
Roll format: log roll length, slit width with tolerance, core diameter
Splice policy: maximum number per roll, marked or unmarked
Document set required, with the language of issue
Label content: product code, lot number, thickness, adhesive, date of manufacture
A purchase order that specifies these six lines removes most of the disputes that otherwise surface at goods-in. It also makes quotations comparable: two suppliers quoting the same nominal thickness are not necessarily quoting the same product.
Frequently asked
Can you supply RoHS and REACH documents for every product?
Yes, for the 3M and tesa constructions we stock. For special-order items the documentation comes with the manufacturer's shipment and adds to the lead time.
Do you provide lot traceability on slit rolls?
Yes. The lot number of the master roll is carried through to the slit roll label and repeated on the certificate of conformity.
What thickness tolerance should we accept?
That depends on the bond line in the design. For a 100 µm construction used in a display stack, a band tighter than the standard tolerance is often worth paying for; for gap filling with a foam, it rarely is.
VIP会员
